Publicité
Les langues disponibles
Les langues disponibles
White film on
Hard water minerals.
inside surface
The affected items are not
corrosion resistant.
A program is not run after
There are rust
adding dishwasher salt.
stains on
Traces of salt have gotten
cutlery.
into the wash cycle.
The cap of the salt container
is loose.
Dishes are rattling against
The
each other.
dishwasher is
The spray arm is knocking
noisy.
against the dishes.
The dishes have not been
arranged properly.
The washing program
selected is too gentle.
The dishes are
Not enough detergent has
not clean.
been used or it is unsuitable.
The spray arm is clogged.
The filters are not clean or
not in the correct position.
Cloudiness on
Combination of soft water
glassware
and too much detergent
White spots
appear on
Hard water area can cause
dishes
limescale deposits.
and glasses
Improper loading
The rinse aid has run out or
The dishes are
too little is being used.
not quite dry.
Wrong program has been
selected.
Error codes
When some malfunctions occur, the display will show the following error codes to warn you.
Codes
Meanings
E1
Longer inlet time.
Not reaching
E3
required
temperature
To clean the interior, use a damp sponge with
dishwasher detergent and wear rubber gloves.
Never use any other cleaner than dishwasher
detergent otherwise it may cause foaming or
suds.
Avoid washing items that are not corrosion
resistant in the dishwasher.
Always run a wash program without any crockery
after adding salt.
Check the cap is secure.
Refer to "Loading the Dishwasher" to rearrange
the dishes.
Refer to "Loading the Dishwasher".
Select a more intensive program.
Refer to "Washing Programs".
Use more detergent or change the detergent.
Rearrange the items so that the spray arm can
rotate freely.
Clean and/or position the filters correctly.
Use less detergent if you have soft water and
select a shorter cycle to wash the glassware and
to get them clean.
Add more detergent.
Refer to "Loading the Dishwasher".
Increase or refill the amount of rinse aid.
Choose a program with long washing time.
Possible Causes
Tap is not opened, or water inlet
is restricted, or water pressure is
too low.
Malfunction of heating element
GB-26
Possible Solution
Turn on the water tap.
Check the water inlet hose is
not blocked. Increase inlet
water pressure.
Contact the after-sales service
to replace the heating
element.
Publicité
