For lightly
Soiled
crockery
and glass
A shorter
wash for
lightly soiled
loads that do
not need
drying
NOTE:
EN 60436: This program is the test cycle. The information for comparability test is in accordance with
EN 60436.
The eco programme is suitable to clean normally soiled tableware, that for this use, it is the most
efficient programme in terms of its combined energy and water consumption, and that it is used to
assess compliance with the EU ecodesign legislation.
Loading the household dishwasher up to the capacity indicated by the manufacturer will contribute
to energy and water savings.
Manual pre-rinsing of tableware items leads to increased water and energy consumption and is not
recommended.
Washing tableware in a household dishwasher usually consumes less energy and water in the use
phase than hand dishwashing when the household dishwasher is used according to the
manufacturer's instructions.
The values given for programmes other than the eco programme are indicative only.
STARTING A WASH CYCLE
1. Turn the water tap on.
2. Open the dishwasher door.
3. Check the filters.
Ensure that they are clean and properly positioned. See the section Cleaning and Maintenance.
4. Check that there is rinse aid and salt.
5. Load the dishes.
Ensure that the spray arm can rotate freely.
6. Add the required amount of detergent into the dispenser according to the Washing Program chart.
7. Close the dishwasher door securely.
8. Press
to switch on the dishwasher.
9. Select the desired washing program by repeatedly pressing
The corresponding programme indicator light will illuminate.
Delay Timer: The delay timer allows you to delay the start of a washing program from 1 hour up
to 24 hours.
Repeatedly press
e.g. H:03 for a 3-hour delay.
Once the delay timer has been set, press
To cancel the delayed start, first press
Pre-wash
Wash(45°C)
4/14g
Rinse
(1 or 2
Rinse(55°C -60°C)
pieces)
Drying
Wash(45°C)
12g
Rinse
(1 piece)
Rinse(45°C)
until the desired delayed start time is shown on the display,
0,760 ~
120
0,805
30
0,560
.
to activate the function.
and then repeatedly press
12,7
Yes
9,6
No
until the display shows