Publicité
Les langues disponibles
Les langues disponibles
Connection of the Drain Hose
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run into the sink,
making sure to avoid bending or crimping it. The height of drain pipe must be less than 1000mm. The
free end of the hose must not be immersed in water to avoid the back flow of it.
Please securely fix the drain hose in either position A or position B.
The installation of the hose should be done by professionals.
Back of dishwasher
Power cord
If leaks are detected, immediately shut the water supply and check the hose connections fully.
Re-tighten the connections if necessary.
If for any reason you are unable to stop the leak yourself, please seek advice from a qualified plumber.
Electrical Connection
The installation of electical equipment should be done by professionals.
•
Do not use an extension cord or an adapter plug with this appliance.
•
Do not, under any circumstances, cut or remove the earthing connection from the power cord.
Ensure the voltage and frequency of the dishwasher correspond to those indicated on the rating plate.
Only insert the plug into an electrical socket which is earthed properly. If the electrical socket to which
the appliance must be connected is not appropriate for the plug, replace the socket, rather than using a
adaptors or the like as they could cause overheating and burns.
Ensure that proper earthing exists before use.
Inlet hose connector
Drain hose
Drain hose
Counter
Publicité
