Publicité
Les langues disponibles
Les langues disponibles
"H:00".
10. If you want to perform a half load wash, press
illuminate.
When you have about or less than 5 place setting dishware to wash, you can choose this function
to save energy and water.
This function can only be used with Intensive, Universal, ECO, Glass and 90 min.
11. If you want to activate turbo speed+ function, press
illuminate.
When this function is activated, the dishwasher will reduce the running time while slightly
increasing water and energy consumption.
This function can only be used with Intensive, Universal, ECO, Glass and 90 min.
12. Press
to start washing.
13. After the program has ended, the diswasher will buzz and stop.
If the dishwasher is set for a delay start, the dishwasher will not buzz.
On the display, "0:00" will flash for a few seconds and then "End" will be displayed.
After 15 minutes, the dishwasher will turn off.
14. The door will automatically open a little to help achieve better drying performance.
Auto open
To select this function, press and hold
the corresponding indicator light will illuminate.
This function cannot be used with Glass and Rapid.
After washing, the door will open automatically to achieve better drying results.
NOTE !
The dishwasher door must not be blocked when set to open automatically. This can disrupt door lock
functionality.
To cancel this function, press and hold
indicator light will go out.
15. Unload the dishes.
WARNING!
• The washing cycle will not start if the dishwasher door is left open or not properly closed.
• Do not open the door when the dishwasher is working since hot water may be ejected, which could
cause scalding.
Adding extra dish
A forgotten dish can be added any time before the detergent dispenser opens. If this is the case, follow
the instructions below:
and the corresponding indicator light will
and the corresponding indicator light will
and
for about 3 seconds and
and
for about 3 seconds and the corresponding
Publicité
