GET SX1 PRO Guide D'installation page 7

6.
Disconnect the wires from the
battery in reverse order: first the
black wire (-) and then the red wire.
7.
Disconnect
TPS connector from the MAIN
connector of the GET SX1 Pro
control unit, put the protection caps
back in place and start the engine.
8.
Restore the throttle position
adjuster to its home position:
rotate clockwise 7 full rotations.
Make sure the engine idle speed is stable. If further idle speed
adjustments are necessary, turn the adjustment screw as
indicated in the workshop manual.
If the engine does not start or does not work correctly after
this procedure, for example due to incorrect installation of the
control unit or incorrect idle speed calibration:
1. Uninstall the GET SX1 Pro control unit.
2. Reinstall the original control unit and restore the correct engine
idle speed.
3. Start the motorcycle and check that the engine is working
properly.
4. Turn off the motorbike, uninstall the original control unit and
reinstall the GET SX1 Pro control unit.
5. Repeat the Zero TPS calibration procedure.
the RESET
7
1
7
ROUND
2
EN