GET SX1 PRO Guide D'installation page 3

6. To change SX1 Pro injection map, it is necessary to use GET
Maya programming software (sold separately).
7. If the bike does not start or the engine is irregular, be sure
that the SX1 Pro ECU chosen is compatible with your bike model
and year, verify that the ECU is connected properly, and always
perform a TPS calibration.
8. The GET ECU supports the connection of multiple
devices, such as SX1 CONNECT, SX1 CONTROLLER, LC-GPA,
QUICKSHIFTER, GPA SWITCH, SL-1 SMART LOGGER:
-to connect up to two devices, use the GL-264-AA harness
(included in the SX1 PRO kit).
-to connect up to four devices, use the GL-266-AA harness
(sold separately).
9. OEM handlebar commands for map change and launch
control will not work after installing GET SX1 Pro ECU. Please
only use GET SX1 CONTROLLER (included in the kit), GET SX1
GPA SWITCH or GET SX1 LC-GPA module (sold separately).
B. SX1 PRO SPECIFIC INSTALLATION
SX1 PRO is a fully programmable plug&play ECU. SX1 PRO is
the best solution both for original and modified engines: it is
possible to adjust the calibration map through both WiGET App,
by using the SX1 CONNECT device, and/or MAYA software.
WiGET App
SX1 Pro comes with 2 maps developed by GET R&D
Department, which can be easily switched thanks to the
Map Switch included in the kit.
3
EN