GET SX1 PRO Guide D'installation page 4

REMEMBER TO WORK UNDER SAFETY CONDITIONS
AND TO KEEP THE ENGINE TURNED OFF.
1.
Find the OEM ECU: check on
your motorbike's workshop manual
where to find it. Press the retainer
clip of the OEM ECU connector
before pulling it: make sure to
remove the connector without
damaging it.
2.
Connect GET SX1 PRO ECU to
OEM connector. Make sure the
connector is properly plugged in, and
the retainer clip is fully engaged.
3.
Remove the oem map switch
from the handlebar.
4.
Install GET SX1 CONTROLLER
by following the instructions in
"SX1 CONTROLLER Installation"
Section in GET SX1 Pro manual.
ATTENTION: Do not connect the SX1 CONTROLLER to
the original handlebar front wiring (black connector).
Connect only to the white connector of the double
wiring GL-264-AA included in the control unit kit.
5.
Install GET SX1 CONNECT following the instructions in the
"SX1 CONNECT Installation" section in the GET SX1 PRO manual.
EN
4