GET SX1 PRO Guide D'installation page 6

2 1
3.
Connect a fully charged 12V
battery to the "RESET TPS" cable:
first the red wire to the positive (+)
pole and then the black wire to the
negative (-) pole.
4.
Rotate the throttle fully
forward to ensure it is in the
closed position during this
operation. Press and hold the
5 sec.
engine stop button for 5 seconds
or until the GET SX1 Pro ECU
turns on the fuel pump and the
MIL (Malfunction Indicator Lamp),
when present. By doing this, the
minimum TPS value is saved.
5.
Rotate the throttle to the fully
open position. While holding it
open, press and hold the engine
stop button for 5 seconds or until
5 sec.
the GET SX1 PRO ECU turns on
the fuel pump and the MIL. By
doing this, the maximum TPS
value is saved.
EN
6