GET SX1 PRO Guide D'installation page 5

C. ZERO TPS CALIBRATION
Zero TPS calibration allows the control unit to correctly recognize
when the throttle is completely closed and to ensure accurate
readings of the fuel level injected into the combustion chamber.
When installing a new control unit or other accessories, GET
recommends performing the Zero TPS calibration.
Idle problems can be caused by incorrect TPS calibration: follow
the steps below to get the best performance from your GET SX1
PRO control unit.
BEFORE STARTING THE CALIBRATION PROCEDURE,
MAKE SURE THE ENGINE STOP SWITCH IS IN RUN
POSITION AND THE THROTTLE IS COMPLETELY CLOSED.
ZERO TPS CALIBRATION
1.
Find the throttle body: check
on your motorbike's workshop
manual where to find it. Rotate
the red throttle position adjuster
counterclockwise for 7 rounds.
2.
Remove the protective caps
and connect the RESET TPS cable
(included in the package) to the
"MAIN" connector of the SX1 PRO
control unit.
5
7
ROUND
EN