Publicité
Les langues disponibles
Les langues disponibles
ACCESSORIES/OPTIONS FOR FOCUS II
In addition to the standard components, the machine can be equipped with the following accessories/options, according to the machine
specific use:
For further information concerning the above-mentioned optional accessories, contact an authorized Retailer.
ACCESSORIES/OPTIONS
See "Parts List" section.
1.
AGM batteries
2.
Brushes and cylindrical brushes of different materials
3.
Pads of different materials
4.
Chemical Mixing System
TROUBLESHOOTING
Trouble
The motors do not work; no warning light turns on.
The machine does not move
(Only for scrubbers with drive)
The 3 battery charge indicators are flashing
simultaneously.
The brushes do not work, the red warning light is on.
The recovery water vacuuming is insufficient.
The solution flow to the brushes is insufficient.
The squeegee leaves marks on the floor.
NOTE
Machine with battery charger installed, cannot operate if the charger is not on board. In case of battery charger malfunction,
contact an authorized Service Center.
For further information refer to the Service Manual, available at any Clarke Service Center.
SCRAPPING
Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the Law
in force:
–
Batteries
–
Brushes/pads
–
Plastic hoses and components
–
Electrical and electronic components (*)
(*)
Refer to the nearest Clarke Center especially when scrapping electrical and electronic components.
Operator's Manual - FOCUS
Possible Cause
The battery connector is disconnected.
The batteries are completely discharged.
The machine has been turned on by using
the ignition key and by keeping one of the
switches pressed.
Brush motor overload.
Foreign materials (tangled threads, etc.) which
may prevent the brush from rotating.
The batteries are discharged.
The recovery water tank is full.
The hose is disconnected from the squeegee. Connect.
The vacuum grid is clogged or the float is
stuck closed.
The squeegee is dirty or the squeegee blades
are worn or damaged.
The tank cover is not properly closed, or the
gasket is damaged, or the compensation hole
is clogged.
The recovery water tank is dirty.
The solution/clean water filter is dirty.
There are debris under the squeegee blades.
The squeegee blades are worn, chipped or
torn.
The squeegee has not been adjusted with the
knob.
II L17 - S20 - L20 - L20 Cyl. - BOOST
®
Remedy
Connect the battery connector.
Charge the batteries.
Turn the ignition key to "0", then try to start the
machine again without pressing the switches.
Use less aggressive brushes and/or avoid
working with extra pressure activated.
Clean the brush hub.
Charge the batteries.
Empty the tank.
Clean the grid or check the float.
Clean and check the squeegee.
Close the cover correctly, or replace the
gasket or clean the compensation hole.
Clean.
Clean the filter.
Remove the debris.
Replace the blades.
Adjust.
L20
®
ENGLISH
33
Publicité
