Clarke Focus II Serie Mode D'emploi page 4

ENGLISH
WARNING! The machine storage temperature must be between +32°F and +104°F (0°C and +40°C).
WARNING! The humidity must be between 30% and 95%.
WARNING! Do not use the machine as a means of transport.
WARNING! Do not use the machine on slopes with an inclination higher than 2%.
WARNING! Do not allow the brushes to operate while the machine is stationary to avoid damaging the floor.
WARNING! In case of fire, use a powder fire extinguisher, not a water one.
WARNING! Do not tamper with the machine safety guards and follow the routine maintenance instructions
scrupulously.
WARNING! Do not allow any object to enter into the openings. Do not use the machine if the openings are clogged.
Always keep the openings free from dust, hairs and any other foreign material which could reduce the air
flow.
WARNING! Do not remove or modify the plates affixed to the machine.
WARNING! If the machine is used according to the instructions, the vibrations are not dangerous. The machine
vibration level is less than 98.42 in/s
WARNING! This machine cannot be used on roads or public streets.
WARNING! Pay attention during machine transportation when temperature is below freezing point. The water in the
recovery tank or in the hoses could freeze and seriously damage the machine.
WARNING! Use the brushes and pads supplied with the machine and those specified in the Operator's Manual.
Using other brushes or pads could reduce safety.
WARNING! In case of machine malfunctions, ensure that these are not due to lack of maintenance. If necessary,
request assistance from the authorized personnel or from an authorized Service Center.
WARNING!
If parts must be replaced, require ORIGINAL spare parts from an authorized Dealer or Retailer.
WARNING! To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant chapter
of this Manual, must be performed by the authorized personnel or by an authorized Service Center.
WARNING! Carefully read all the instructions before performing any maintenance/repair procedure.
WARNING! Do not wash the machine with direct or pressurized water jets, or with corrosive substances.
WARNING! The machine must be disposed of properly, because of the presence of toxic-harmful materials
(batteries, etc.), which are subject to standards that require disposal in special centers (see Scrapping
chapter).
4
(2.5 m/s ) (98/37/EEC - EN 1033/1995).
2 2
Operator's Manual - FOCUS II L17 - S20 - L20 - L20 Cyl. - BOOST
®
L20
®