Jotul I 400 Manuel D'installation Et Données Techniques page 19

Table of contents
Installation manual with technical data
1.0 Regulatory information ............................. 19
2.0 Technical data ............................................ 19
3.0 Installation ................................................20
4.0 Service ......................................................... 22
5.0 Optional Equipment .................................. 22
Figures .................................................................. 43
Table of contents
General use and maintenance manual
6.0 Safety precautions
7.0 Choice of fuel
8.0 Use
9.0 Maintenance
10.0 Operational problems - troubleshooting
On all our products there is a label
Product:
Jøtul
indicating the serial number and
Room heater fired by solid fuel
year. Write this number in the
Standard :
Minimum distance to adjacent combustible materials:
Minimum distance to adjacent combustible materials:
place indicated in the installation
Emission of CO in combustion products :
Flue gas temperature
:
Nominal heat output :
instructions.
Efficiency
:
Operation range :
Fuel type :
Operational type :
The appliance can be used in a shared flue.
Always quote this serial number when
Country Classification Certificate/ Approved by
standard
contacting your retailer or Jøtul.
Norway Klasse II
SP Sveriges Provnings- och
Sweden SP
OGC
Forskningsinstitut AB
SP Swedish National
Testing and Research
EUR Intermittent EN
Institute
Follow user`s instructions. Use only recommended fuels.
Montage- und Bedienungsanleitung beachten.
Verwenden Sie nur empfohlenen Brennstoffen.
Respectez les consignes d'utilisation. Utilisez uniquement
les combustibles recommandés.
Serial no: Y-xxxx, Year: 200x
Manufacturer: 221546
Jøtul AS
POB 1441
N-1602 Fredrikstad
Norway
Serial no.
1.0 Regulatory information
The installation of a fireplace must take place in accordance with
each country's laws and regulations.
All local ordinances, including those that refer to national and
European standards, must be complied with when products are
installed.
Both an installation manual with technical data and a general
user and maintenance manual accompany the product. The
installation can only be taken into use after it has been checked
by a qualified inspector.
A rating plate made of a heat-resistant material is fixed to the
heat shield. This provides information on identification and
documentation of the product.
2.0 Technical data
Material:
Finish:
Type of fuel:
Max. log length:
Operating range:
)
OGC emissions (13 % O
2
Smoke outlet:
Flue pipe dimension:
Outside air connection:
Weight Panorama/Bifold:
Weight Flat
Optional extras:
Product dimensions, distances: See fig. 1
Technical data in acc. with EN 13229
Nominal heat output:
Flue gas mass flow:
Recommended chimney draught:
Efficiency:
CO emissions (13 % O ):
2
Flue gas temperature:
Operating mode:
"Intermittent combustion" here means normal use of a stove.
That is to say, if you want to continue producing heat, you add
more fuel as soon as the previous load of wood has burnt down
to embers.
ENGLISH
Cast iron
Paint
Wood
40 cm
3.7-9.0 kW
3
86 mg/m n
Top
2
Ø 150 mm/177 cm cross
section
Alu. flex - Ø 100 mm
Approx. 125 kg
Approx. 110 kg
Ash solution, kit for outside
air connection, top and
bottom grid, side grid, flat
smoke bell, decorative frame
6.0 kW
7.3 g/s
12 Pa
74 %@6.0 kW
0.19%
o
259 C
Intermittent
19