Poulan Pro PP025 Manuel D'instructions page 11

CUTTING METHODS
_WARNING:
Use minimum speed
and do not crowd the line when cutting around
hard objects (rock, gravel, fence posts, etc.),
which can damage thetrimmer head, become
entangled in the +ine, or be thrown causing a
serious hazard,
• The tip of the line does the cutting, You will
achieve the best performance and
mh_imum line wear by not crowding the +ine
into the cutting area, The right and wrong
ways are shown below.
Tip of the Line
Does The Cutting
.igor
Line Crowded Into
Work Area
• The line will easily remove grass and
weeds from around walls, fences, trees and
flower beds, but it also can cut the tender
bark of trees or shrubs and scar fences.
• For trimming or scalping, use less than full
throttle to increase line life and decrease head
wear, especially:
• During light duty cutting.
• Near objects around which the line can
wrap such as small posts, trees or fence
wire,
• For mowing or sweeping, use full throttle for
a good clean job,
TRIMMING - Hotd the bottom of the trimmer
head about 3 inches (8 cm) above the ground
and at an angle, Allow only the tip of the line to
make contact, Do not force trimmer line into
work area,
Trimming _ ,j +
3+nches l+ore/ +"
above ground T - _"_'_ '
SOALPING- The scalping technique re-
moves unwanted vegetation down to the
ground, Ho+d the bottom of the trimmer head
about 3 inches (8 cm) above the ground and
at an angle. Allow the tip of the line to strike the
ground around trees, posts, monuments, etc.
This technique increases line wear.
MOWING - Your trimmer is ideal for mowing
in places conventional lawn mowers cannot
reach, in the mowing position, keep the line
parallel to the ground. Avoid pressing the
head into the ground as this can scalp the
ground and damage the tool.
Mowing
IJ
-
SWEEPING - The fanning action of the rotat-
ing line can be used for a quick and easy
clean up, Keep the line parallel to and above
the surfaces being swept and move the tool
from side to side,
Swe_.. .....
R2_WAHI_III_I_: Disconnect the spark
plug before performing maintenance except
for carburetor adjustments.
11
HELPFUL TIP
IMPORTANT: Have aft
repairs Other than the rec-
ommended maintenance
described in the instruction
manual performed by an
authorized service dealer.
If any dealer other than an authorized
service dealer performs work on the
product, Poulan PRO may not pay for
repairs under warranty. It is your re-
sponsibility to maintain and perform
general maintenance.