Publicité
Les langues disponibles
Les langues disponibles
Note!
Material damage!
•
Make sure that the vacuum cleaner is
suitable for use with the electric power
tool. Most dry vacuum cleaners for
domestic use are well suited to this
purpose.
•
The vacuum cleaner is particularly use-
ful if many cuts are being performed
successively. It means that less frequent
stops are required to clean the electric
power tool and the workplace.
•
When you are cutting materials which
may produce dangerous dust, always
use a vacuum cleaner. This applies, in
particular, to hardwoods, MDF sheets
and ceramics.
SETTING THE CUTTING DEPTH (FIG. F)
1. Loosen the cutting depth limiter
2. Set the cutting depth according to the
scale and tighten the cutting depth lim-
iter
.
2
3. For wood and plastics, the cutting depth
should be selected to be a little deeper
than the material thickness.
4. A wood underlay can be used to achieve
a better cutting quality. The wood
underlay will, however, be damaged.
CONNECTION TO THE POWER SUPPLY
Before connecting, make sure that the data
on the label match the mains electricity.
Always pull out the power plug before mak-
ing any adjustments to the power tool.
WARNING!
Risk of injury!
•
Before undertaking any work on the
electric power tool, unplug it from the
mains!
•
Do not use tool inserts which are defec-
tive or which exhibit tears or fissures.
7063814-Precision-saw-Ma-2012-14.indb 37
7063814-Precision-saw-Ma-2012-14.indb 37
•
Do not use a flange or flange nut with a
hole larger or smaller than the hole in
the tool insert.
•
Only use tool inserts of the same type
as those delivered with the electric
power tool. Seek advice from a special-
ist trader.
OPERATION
General instructions
•
Select a suitable tool insert for the
material that is to be worked on.
•
Check the condition and sharpness of
the tool insert.
•
Always hold the electric power tool with
a firm grip.
•
Exert no force! Push the electric power
tool forwards, gently and evenly.
•
The electric power tool must not be
braked with the hand or by applying
lateral pressure.
2
.
•
The safety guard may not be blocked
and must be returned to the starting
position after the final working step.
•
Before use of the electric power tool,
inspect the function of the safety guard
with the tool unplugged from the mains.
•
Before each use of the electric power
tool, make sure that the safety mecha-
nisms such as the safety guard, flanges
and adjustment devices are functioning
and/or are correctly installed and
fastened.
•
A suitable dust extraction system is to
be connected to the dust extraction
connection (6). Make sure that the dust
extraction is correctly and securely
attached.
SWITCHING ON AND OFF (FIG. A)
Switching on:
Push the safety switch
one finger and then press the On/Off switch
keeping it pressed.
1a
Switching off:
Let go of the On/Off switch
English
1b
forward with
1a
.
37
28/06/2021 12:01
28/06/2021 12:01
Publicité
