Publicité
Les langues disponibles
Les langues disponibles
b. Never bring your hand into the
vicinity of a rotating tool insert. The
inserted tool could move over your hand
if kickback occurs.
c. Avoid the area in front of and behind
a rotating cutting wheel. A kickback
will send the electric power tool in the
opposite direction to the movement of
the grinding disc at the point where it
jams.
d. Work extremely carefully in the
neighbourhood of corners, sharp
edges etc. Prevent the tool insert
from recoiling from the workpiece
and jamming. The rotating tool insert
bends at corners and sharp edges or if
it rebounds and may jam itself. This
causes a loss of control or kickback.
e. Do not use any chainsaw or toothed
saw blade, nor any segmented
diamond disc, with slots wider than
10 mm. Such tool inserts frequently
cause a kickback or loss of control of
the electric power tool.
f. Avoid jamming of the cutting wheel or
too high a contact pressure. Do not
make excessively deep cuts. An
overload of the cutting wheel increases
its stress and its susceptibility to tilting
or jamming and, hence, increases the
possibility of a kickback or break in the
grinding wheel.
g. If the cutting wheel becomes jammed
or if you interrupt the work, switch
the device off and keep it held gently
until the disc has come to a standstill.
Never attempt to remove a still-running
cutting wheel from the cut, otherwise
kickback may result. Find and remove
the cause for the jamming.
h. Do not switch on the electric power
tool again, while it is still in the
workpiece. Allow the cutting wheel to
first reach its full rotation speed before
carefully continuing the cut; otherwise,
the disc may snag, jump out of the
workpiece or cause a kickback.
i. Provide support for large workpieces,
to reduce the risk of a kickback
7063814-Precision-saw-Ma-2012-14.indb 33
7063814-Precision-saw-Ma-2012-14.indb 33
through jamming of the cutting
wheel. Large workpieces can bend
under their own weight. The workpiece
must be supported on both sides of the
disc, as well as both in the
neighbourhood of the separation cut
and at the edges.
j. Be especially careful when making
"pocket cuts" in existing walls or
other non-visible areas. The immersed
cutting tool can cause a kickback when
cutting into gas or water pipes, electric
cables or other objects.
ADDITIONAL SAFETY INSTRUCTIONS
FOR ABRASIVE APPLICATIONS
a. Warning! Don't inhale or touch the
generated dust, this dust is a hazard
for the operator and for other people
nearby. Therefore, avoid using harmful /
toxic materials, such as items coated in
lead containing paint, some types of
wood and metal and use dust collection
equipment and personal protective
equipment, such as a dust mask.
b. Always wear ear protection!
c. Hold the electric power tool by the
insulated handling surfaces, since
the saw blade can make contact with
its own power cable. Contact live wire
places a voltage on the metal parts of
the electric power tool and will lead to
an electric shock.
SAFETY AND OPERATING
INSTRUCTIONS FOR DIAMOND
GRINDING WHEELS
USE
Only use the cut off grinding disc for cut off
grinding and not for rough grinding! Only
use the cut off grinding discs for the materi-
als indicated and not for any other materials.
Risk of injury! Cutting and cooling!
GENERAL INFORMATION
This tool insert is fragile, therefore extreme
care is required when handling it. The use of
damaged and incorrectly tensioned or
English
33
28/06/2021 12:01
28/06/2021 12:01
Publicité
