Publicité
Les langues disponibles
Les langues disponibles
laterally. Lateral movements can cause
the saw blade to jam and hence result in
kickback.
d. Do not put down the saw on the
workbench or floor, without the lower
safety guard covering the saw blade.
When slowing down after use, an
unprotected saw blade will move the
saw in the direction opposite to the
cutting direction and will saw whatever
lies in its path. Pay attention, therefore,
to the deceleration time of the saw.
e. Use only sawblades with the correct
diameter according to what is printed on
the saw.
f. When sawing plastics please ensure not
to overheat the saw teeth tips to avoid
melting the plastic.
SAFETY INSTRUCTIONS FOR CUT OFF
GRINDING APPLICATIONS
Safety instructions for cut off grinders
a. The safety guard for the electric
power tool must be securely attached
and adjusted so that maximum safety
is attained, i.e. the smallest possible
portion of the grinding wheel shows
openly to the operator. Make sure
that you and any other nearby
individuals are not in the plane of the
rotating grinding disc. The safety
guard is intended to protect the operator
from fragments and from accidental
contact with the grinding wheel.
b. Use only diamond cutting discs for
your electric power tool. The fact that
you can attach an accessory to your
electric power tool, does not guarantee
that it is safe to use.
c. The permissible rotary speed of the
tool insert must be at least as high as
the quoted maximum rotary speed of
the electric power tool. Accessories
which are rotated faster than their
permissible speed may break or fly off.
d. Grinding wheels may only be used for
their recommended types of
application, e.g. never grind with the
side face of a cutting wheel. Cutting
7063814-Precision-saw-Ma-2012-14.indb 31
7063814-Precision-saw-Ma-2012-14.indb 31
wheels only remove material using
the edge of the disc. Application of
lateral forces to these grinding wheels
can cause them to break.
e. Always use an undamaged clamping
flange of the correct size and shape
for your selected grinding disc.
Suitable flanges support the grinding
disc and so reduce the danger of it
breaking.
f. Do not use worn out grinding discs
from larger electric power tools.
Grinding discs from larger electric power
tools are not suitable for the higher
rotary speeds of small electric power
tools and can break during use.
g. The outer diameter and thickness of
tool inserts must correspond with the
given characteristics of your electric
power tool. Wrongly-sized tool inserts
cannot be sufficiently shielded or
controlled.
h. Grinding discs and flanges must fit
exactly on the grinding spindle of
your electric power tool. Tool inserts,
which do not fit exactly to the grinding
spindle of the electric power tool, will
rotate unevenly and vibrate strongly and
may lead to loss of control.
i. Do not use damaged grinding discs.
Before each use, inspect the grinding
wheels for any chipping or cracks. If
the electric power tool or the grinding
disc is dropped, inspect it for
damage or replace it with a
undamaged grinding disc. When you
have inspected and installed the
grinding disc, make sure that you,
and any other nearby individuals,
remain out of the plane of the rotating
grinding disc and then allow the tool
to rotate at its highest speed for one
minute. Damaged grinding discs usually
break during this test time.
j. Wear protective clothing and
equipment. Depending on the
application, use either a full face
visor, protective goggles or safety
glasses. As far as appropriate, where
a dust mask, hearing protection,
English
31
28/06/2021 12:01
28/06/2021 12:01
Publicité
