Publicité
Les langues disponibles
Les langues disponibles
English
installed tool inserts is dangerous and can
result in serious injury.
HANDLING AND STORAGE
Tool inserts must be carefully handled and
transported. Tool inserts should be stored in
such a way that they are not exposed to any
mechanical damage or damaging environ-
mental influences.
To avoid damage, remove the tool insert
before transporting an electric power tool.
SELECTION AND SAFE AND PROPER USE
Pay attention to the data on the label or on
the tool insert, such as the restrictions on
use, safety instructions or other advice. Do
not alter the characteristic direction of
motion of the tool insert. If there is ambiguity
over the selection of tool inserts, contact the
manufacturer or a specialist. Adhere to the
permissible rotation speeds for the tool
insert and the electric power tool.
BEFORE USE
Tool inserts must be given a visual inspec-
tion before each start-up. Do not use dam-
aged tool inserts. Secure the piece to be
worked on.
INSERTING AND CHANGING
Tighten the tool inserts in accordance with
their instructions and those of the electric
power tool's manufacturer. The tightening of
tool inserts should only be undertaken by
qualified persons. After each tightening,
carry out a test run for a suitable length of
time, during which the characteristic maxi-
mum working speed of the tool insert may
not be exceeded. Always tighten tool inserts
without introducing any out-of-roundness.
USE
1. Pay attention to the operating instruc-
tions of the electric power tool with
which you are using the tool insert.
2. Before start-up, attach an appropriate
safety device to the electric power tool.
Do not carry out any work without pro-
tection provided through safety devices.
34
7063814-Precision-saw-Ma-2012-14.indb 34
7063814-Precision-saw-Ma-2012-14.indb 34
3. Use personal protective clothing and
equipment suitable for the type of
machine used and the application
undertaken, e.g. eye and face protec-
tion, hearing protection, respirators,
safety shoes, safety gloves and other
protective clothing.
4. Only undertake work for which the tool
insert is suitable (taking into considera-
tion use restrictions, safety instructions
and other data).
5. Switch off the electric power tool before
placing it on the workbench or on the
floor and wait until the tool insert is
stationary.
6. For cut off grinding, place the tool insert
directly in the gap, so that the electric
power tool does not tilt.
7. Do not go backwards and forwards in
the material, rather pull the tool calmly
through it.
8. Work only at right angles and in straight
lines, to avoid the danger of cracking in
the core or segments breaking off.
9. Do not exert a strong grinding pressure;
the weight of the electric power tool will
suffice.
10. Do not include any cooling breaks.
11. Caution! The tool insert will become very
hot during the work; only touch it with
safety gloves, after it has cooled down.
SAFETY INSTRUCTIONS FOR
HANDLING SAW BLADES
1. Only use tool inserts if you are familiar
with their handling.
2. Do not exceed the maximum rotation
speed. The maximum permissible rota-
tion speed indicated on the tool insert
must not be exceeded. Remain within
the rotation speed range, if indicated.
3. Do not use cracked tool inserts. Throw
away any cracked tool inserts. Repair is
not permitted.
4. Clean off any contamination, fat, oil or
water from the clamping surfaces.
28/06/2021 12:01
28/06/2021 12:01
Publicité
