Stereo Channel - Montarbo FiveO EVE Série Mode D'emploi

1.2 sTEREO ChANNEL

Line inputs
LINE IN – BAL OR UNBAL
9
Each stereo channel has two balanced TRs 6,35mm. (1/4") line level input connectors for left and
right channels. Connecting a mono source, you must connect it to the connector marked "L"(left),
please read BAL to learn more. stereo channels are designed to handle typical line level signals.
Both inputs will also accept unbalanced devices (Ts cables).
frequencies. In particular this filter can reduce stage noise and singer mic handling noises.
FX, pAN, CLIp LED, LEVEL
10
FX
FX send enables you to feed signals, through each channel knob, to FX bus. As the name suggests,
EVE consoles FX send is intended to drive the internal effects device (reverb, delay, multi-effects
etc.). FX send is configured post-fader, i.e. the amount of each channel send is determined by
each channel FX send as well as from the knob LEVEL setting. Each channel FX send is mono and
features up to +15 dB gain. The bus signal is present also at FX sEND output
of the console, thus being available for an external effects device too. The return from external
effects unit is then brought back into a stereo channel of the console.
11
+4/-10
This switch allows you to choose the stereo input sensitivity. +4dBu perfectly suits for all professional
devices level, while –10dBV is for semi-professional, home-recording and most keyboard output level.
–10dBV input level obviously is more sensitive (requires less level to drive the signal) than +4 dBu.
BAL
12
The BAL control determines level balance of left and right input signals relative to each other before
both signal are routed to the main stereo mix bus. If a stereo channel operates in mono, just one
cable connected to L MONO 6,35mm. (1/4") jack, the control has the same function as the PAN
control used in the mono channels.
CLIP LED
13
Each stereo channel CLIP LED is lit when the input signal is driven too high, which could cause distortion.
If this happens, use the TRIM control to reduce the preamp level until the CLIP LED turns off.
14
LEVEL
The LEVEL control determines the level of the channel signal in the main mix.
Owner's manual | EVE sERIEs professional mixer
12
MIXING CONSOLES WITH BUILT-IN EFFECTS
(All models but EVE5, have +4/-10 switch, FX send, and CLIP LED)