Phones; Main Mix - Montarbo FiveO EVE Série Mode D'emploi

1.4 phONEs

PHONES jack
24
The 6,35mm. (1/4") stereo PHONEs jack is provided for your monitoring headphones connection.
PHONES level
25
After the MAIN MIX control, the main mix signal is sent to CTRL ROOM/PHONEs control to adjust
the level of headphones, as well as CTRL ROOM OUT.
PHONES/CTRL MUTE switch
26
The PHONEs/CTRL MUTE switch allows you to instantaneously mute (OFF position) the listening
session, thus listening to FoH sound only.EVE5 is provided with PHONEs level knob only, which is
located just under the LED ladder and above MAIN MIX knob.

1.5 mAIN mIX

27
MAIN OUT
The MAIN OUT connectors are unbalanced 6,35mm. (1/4") Ts jacks, the standard output level is
0 dBu. The MAIN MIX control adjusts the volume of these outputs.
28
CTRL ROOM OUT (not present in EVE5)
The CTRL ROOM OUT connectors are unbalanced 6,35mm. (1/4") Ts jacks, driving your studio
monitors. The level is adjusted by CTRL ROOM/PHONEs knob, eventually muted by PHONEs/CTRL
MUTE switch. since the signal is received from main mix path, the level is affected by MAIN MIX
control settings.
POWER
29
When the blue POWER LED is lit, it means the console is powered.
+48V
30
This LED is lit when the PHANTOM switch is depressed, indicating that all XLR connectors receive
48V Phantom power.
LED level ladder
31
This high-precision 4-segment level ladder accurately displays the output signal level. -20dB green
LED lit indicates you signal presence. 0dB green LED is important when recording to digital recorders,
since these recorders should be overloaded by higher signals, driving your recordings to distortion.
+6dB yellow LED warns you about a signal which is still good for analogue systems but very close
to overload. CLIP red LED indicates you an overload, so you should immediately reduce the MAIN
MIX control, then check which input channel LEVEL is too hot.
Owner's manual | EVE sERIEs professional mixer
16
MIXING CONSOLES WITH BUILT-IN EFFECTS