Fx (Not Present In Eve5) & Phantom Sections - Montarbo FiveO EVE Série Mode D'emploi

1.3 FX & phANTOm sECTIONs
FX SEND + PHONES OUT
19
The FX sEND 6,35mm. (1/4") Ts unbalanced output connector (not present in EVE5) can be
connected to the input of an external effects unit. The post-fader FX mix you created using each
input channel FX knob is sent to the external effects unit via the FX sEND output.
24bit DSP
20
Your mixing console has an internal professional DsP effect processor featuring 24-bit A/D D/A
converters. This powerful DsP provides you 99 studio quality pre-sets, including 40 REVERBs, 20 DELAYs,
14 MODulations, 6 PITCH effects as well as 20 MULTI-effects. The display shows the effect program
number and contains a sIGNAL and CLIP LED. The sIGNAL LED should always be on, thus showing
the presence of a signal. While the CLIP LED should flash only on music peaks; if it's continuously lit
it means you are over-driving the effects processor, leading it to unpleasant distortion. In this case
please decrease channels FX send.
PROGRAM PUSH
21
The PROGRAM encoder with push functions can be used for two different operations. By turning
the PROGRAM encoder, you can scroll among effect numbers. When the number of the desired
pre-set blinks in the display you have to press the PROGRAM encoder; the display stops to blink
and your desired effect is on.
FX TO MAIN
22
The FX TO MAIN knob feeds the main mix with the quantity of effect set with each channel knob.
23 PHANTOM
Engage this switch to provide Phantom power to all the MIC XLR connectors. Phantom power is
required to operate condenser microphones, and even some dynamic microphones, but it's dangerous
for ribbon microphones, please double check your microphone manual to learn if your microphone
needs the Phantom power. Over the LED level ladder there's +48LED, when it's lit the PHANTOM
switch is on.
 When Phantom power is ON, NEVER USE unbalanced XLR connectors or adaptors (PIN 1 connected to PIN 2
or PIN 3) connected to MIC input connectors; you should seriously damage the microphone as well as the mixer
phantom circuitry.
 To avoid the possibility of "pop" noise, turn all the output levels down before operating this switch.
 Please do not connect microphones to the mixer (or the stage-box/wall-box) as long as the phantom power
supply in switched on. Connect the cables of the microphones before you switch on the power supply. Your
sound system should be turned off or muted when you activate the phantom power supply. After switching on,
wait about one minute to allow console circuitry stabilization.
Owner's manual | EVE sERIEs professional mixer
14
MIXING CONSOLES WITH BUILT-IN EFFECTS