Montarbo FiveO EVE Série Mode D'emploi page 11

1.1 mONO ChANNEL
FX, pAN, CLIp LED, LEVEL
FX
5
FX send enables you to feed signals, through each channel knob, to FX bus. As the name suggests,
EVE consoles FX send is intended to drive the internal effects device (reverb, delay, multi-effects
etc.). FX send is configured post-fader, i.e. the amount of each channel send is determined by
each channel FX send as well as from the knob LEVEL setting. Each channel FX send is mono and
features up to +15 dB gain.
The bus signal is present also at FX sEND output of the console, thus being available for an external
effects device too. The return from external effects unit is then brought back into a stereo channel
of the console.
PAN
6
The PAN control determines the position of the channel signal within the stereo field. This control
features a constant-power characteristic, which means the signal is always maintained at a constant
level, independently of the stereo panorama position.
7 CLIP LED
Each mono channel CLIP LED is lit when the input signal is driven too high, which could cause
distortion. If this happens, use the TRIM control to reduce the preamp level until the CLIP LED turns off.
8 LEVEL
The LEVEL control determines the level of the channel signal in the main mix.
(All models but EVE5 have FX send)
Owner's manual | EVE sERIEs professional mixer
11