Dometic RMD10.5S Instructions De Montage page 23

RMD10
A
NOTICE!
Always use a backup wrench (size 17 mm) when connecting the gas
supply line to the refrigerator's gas inlet fitting.
Item in
fig. h,
Description
page 10
1 Gas supply line
2 Gas inlet fitting:
3/8" SAE (UNF 5/8" - 18) male flare connection
3 Gas valve shut-off cock
4
Backup wrench (17 mm/
➤ Manually connect the gas supply line (fig. h 1, page 10) to the gas inlet fitting of
the refrigerator (fig. h 2, page 10).
Always use a backup wrench when connecting the gas supply line to the gas
inlet fitting.
➤ Have a leak test and a flame test performed by an authorized specialist after
professional installation.
Ensure you are issued with a certificate of inspection and hand this certificate to
the end user for safekeeping.
Instructions for the authorized specialist
➤ Check all connections for gas leaks with soap and water.
➤ Do not use a naked flame for detecting leaks.
➤ Ignite the burner to ensure correct operation of gas valve, burner and ignition.
➤ If the device fails to operate correctly after all checks have been carried out, refer
to the authorized service provider in your area.
Conditions for the gas supply
➤ Ensure the following:
The gas supply system must incorporate a pressure regulator to maintain a
supply pressure of max. 13.5 inches water column, static (no load).
➤ Disconnect the refrigerator and its shut-off valve from the gas supply before test-
ing the gas supply system, if test pressures are higher than 0.5 psig.
EN
Connecting the refrigerator
5
/ in.)
8
23