Dometic RMD10.5S Instructions De Montage page 20

Installing the refrigerator
➤ Make an air inlet vent and an air outlet vent in the outer wall with the size of
249 mm x 490 mm (9.8 in. x 19.29 in.).
When doing so, observe the information, see chapter "Preparing the installa-
tion" on page 17.
If the ventilation grill of the air inlet vent cannot be installed flush with the floor of the
niche, install an inlet vent in the floor. Any leaking gas can thus flow downwards.
➤ Make an air inlet vent of at least Ø 40 mm (1.57 in.) in the floor (fig. 8 1, page 8)
behind the refrigerator near the gas burner.
➤ Shield the end of the opening with a deflector to prevent sludge or dirt from get-
ting inside while driving (fig. 8 2, page 8).
If you have to use a roof vent instead of the air outlet vent:
➤ Cut out a section in the roof. Refer to the roof vent instruction manual for the
required dimensions.
When doing so, observe the information in chapter "Preparing the installation"
on page 17.
5.4 Installing the ventilation grill
I
NOTE
Use exclusively original Dometic ventilation grills to ensure safe
operation.
No. in
fig. 9, page 8
1
2
3
4
➤ Seal the installation frame to make the connection waterproof (fig. 0, page 9).
➤ Insert the installation frame and screw it down tightly (fig. a, page 9). Use all the
fixing holes for this.
➤ Insert the ventilation grill as shown (fig. b, page 9).
20
Description
Slider
Ventilation grill
Installation frame
Fastening for condensation drain
RMD10
EN