Panasonic Read Me First FZ-G2 Serie Manuel D'utilisation page 30

First-time Operation
3
3
2
4
4
<For tablet>
4
30
3 Open the display
1 <Only for model with keyboard base>
A Pull out the handle.
l If you do not pull out the handle before opening the
B Rotate the latch (D) to the arrow direction.
C Hold the dents with both hands, and lift the display slightly.
D Hold the side of the computer with either of your hands
D
and then lift up the display to open.
IMPORTANT
l Do not open the display wider than necessary (150° or
more), and do not apply excessive pressure to the LCD. Do
not open or close the computer holding the edge of the LCD
segment.
4 Turn on the computer
Press and hold the power switch
lights.
E
IMPORTANT
l Do not press the power switch repeatedly.
F
l Do not perform the following operation until the First-time
Operation is completed.
Ÿ <Only for model with keyboard base> Touching the release
lever (E) and detach lock (F)
Ÿ <Only for model with keyboard base> Detaching the tablet
from keyboard base
Ÿ Disconnecting the AC adaptor
Ÿ Pressing the power switch
Ÿ <Only for model with keyboard base> Closing the display
Ÿ Any changes from the default setting of the Setup Utility
l Once you turn off the computer, wait for ten seconds or more
before you turn on the computer again.
l When the CPU temperature is high, the computer may not
start up to prevent overheating of the CPU. Wait until the
computer cools down, and then turn the power on again. If
the computer does not power on even after cooling down,
contact Panasonic Technical Support (è
structions - Reference Manual).
display, the computer may fall over due to the weight
of the display.
until the power indicator
Operating In-