Sub-Zero IC30RLH Guide D'utilisation Et D'entretien page 8

ST O R A G E
Refrigerator Storage
GL A S S S HE LVE S
To reposition a glass shelf:
To remove, tilt the shelf up, then lift up and out. Refer to
1
the illustration below.
To reinstall, insert the shelf in the tracks along the back
2
wall, then lower the front until it locks into position.
The stationary glass shelf at the bottom of the compartment
should be placed with the beveled edge facing front. Rear
support legs space the shelf away from the back wall to
ensure proper air flow through the unit.
Use care when handling glass shelves to
IMPORTANT NOTE:
prevent breakage or scratching the interior.
CAUTION
Glass shelves should warm to room temperature before
immersing in warm water.
Glass shelf removal
8 | Sub-Zero Customer Care 800.222.7820
R EFR IG ERATO R D RAW ER S
To remove/reinstall a refrigerator drawer:
To remove, pull the drawer open until it stops. Lift the
1
front of the drawer slightly and pull straight out. Refer to
the illustration below.
To reinstall, pull the drawer carrier out and align the
2
bottom of the drawer with the carrier. Slide the drawer
back into position
.
To reposition a refrigerator drawer divider:
To remove, pull the divider straight up.
1
To reinstall, align tabs on the divider with notches in the
2
drawer and push down.
Refrigerator drawer removal Refrigerator drawer removal