CASO DESIGN C1800M Mode D'emploi Original page 47

13.6 Electrical connection
DANGER
► Risk of electrocution
► Touching internal compponents may cause serious, severe and fatal injuries.
► Do not disassemble the appliance.
► Improper grounding can cause electrical shocks. Do not use a power outlet if it is not
properly installed and grounded.
In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
 The electrical outlet must be protected by a 16A safety cut-out switch, separately from
other electricity consumers,
 The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under the
oven or over hot or sharp surfaces.
 This appliance must be electrically grounded. In case of a short circuit grounding will
protect against electric shocks because the electrical current is diverted through the
grounding lead. The appliance is fitted with an appropriate cable with a ground lead
and a grounded safety plug. The plug must be inserted into a properly installed and
grounded outlet.
 The device has to be grounded additionally for potential equalization, as usual in
commercial kitchens. If in doubt, ask your qualified electrician.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician. The manufacturer cannot be made responsible
for damages that are caused by a missing or damaged protective conductor.
13.6.1 Extension cables
 The power cable is kept intentionally short to reduce the risk of tangling or presenting a
tripping hazard.
 If a longer cable or an extension cable is required:
 1) The power rating of the cable or extension cable must be no less than the rating of
the appliance.
47