MINN KOTA Wireless Stomp Switch Manuel D'utilisation page 7

INSTALLATION
Installing the Wireless Stomp Switch
1
ITEM(S) NEEDED
a. Review the Mounting Considerations to determine
an acceptable mounting location. Once a location is
selected, take the Wireless Stomp Switch Assembly
(Assembly #A or B) and remove the Pedestal from
the Base by squeezing the Tab on the top side of the
Stomp Switch by the molded logo and pulling the
Stomp Switch and Pedestal apart.
The Pedestal comes attached to the
NOTICE:
Wireless Stomp Switch and needs to be removed
for installation.
This installation process should
NOTICE:
be repeated for both Wireless Stomp Switch
Assemblies (Assembly #A and B).
2
b. The Pedestal has three Mounting Holes that are
used to secure it to the boat. The bottom side of
the Pedestal is smooth. The smooth side should be
placed down, towards the boat when the Pedestal is
installed. Position the Pedestal at the selected location
and mark the Mounting Holes with a pencil or similar
marking tool.
©2024 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE WIRELESS STOMP SWITCH
#A or #B x 1
Stomp Stomp
Switch Switch
Pedestal Pedestal
Notch Notch
Pedestal Pedestal
(top) (top)
Pedestal (bottom) Pedestal (bottom)
Tab Tab
Marked Location Marked Location
Mounting Holes Mounting Holes
minnkota.johnsonoutdoors.com | 7