MINN KOTA Wireless Stomp Switch Manuel D'utilisation page 15

Retracting the Raptor from the Wireless Stomp Switch
Use the Up button on the UP Stomp Switch to retract the Raptor anchor.
1
a. To AUTO retract the Raptor, press and then release
the Up button on the UP Stomp Switch. To
CONTINUALLY retract the Raptor, press and hold the
Up button.
b. While AUTO retracting, the action can be paused
by either pressing the Up
pressing the Down
CONTINUALLY retracting, the action can be paused on
the UP Stomp Switch by releasing the Up
The three red LED's
NOTICE:
begin to scroll in a clockwise direction to indicate the
switch is executing an AUTO retract command.
c. The paused retraction can be resumed by pressing
the Up button again in the same manner.
d. If AUTO retracting, the anchor will stop when the
anchor is fully retracted. If CONTINUALLY retracting
the button should be released when the anchor is
fully retracted.
When two Raptors are paired, both Raptors
NOTICE:
will retract.
Be sure that the Raptor is clear of obstructions and persons while deploying or retracting. Take care that neither you nor other persons
approach the Raptor too closely, while operating, neither with body parts nor with objects. The Raptor is powerful and may endanger
or injure you or others. While the Raptor is operating, watch out for persons swimming and for floating objects. Persons who lack the
ability to run the Raptor or whose reactions are impaired by alcohol, drugs, medication, or other substances are not permitted to use
this product.
The spaces between the Outer Arm, Inner Arm, Spike and brackets of the Raptor can create a pinch point. Do not come in contact with an
area of the Raptor that may cause a pinch point while it is moving in any direction to avoid the risk.
©2024 Johnson Outdoors Marine Electronics, Inc.
button again, or by
button. While the anchor is
button.
under the button will
WARNING
CAUTION
USING THE WIRELESS STOMP SWITCH
UP/
retract
Auto Up Button/
Pairing Button
UP
Stomp Switch
minnkota.johnsonoutdoors.com | 15