Publicité
Les langues disponibles
Les langues disponibles
CLEARING PAIRED TALONS/RAPTORS FROM THE WIRELESS STOMP SWITCH
CLEARING PAIRED TALONS/RAPTORS FROM THE WIRELESS STOMP SWITCH
The Wireless Stomp Switch was designed so that all paired Talons/Raptors can be cleared from memory. Each Wireless Stomp Switch
should be cleared, so be sure to repeat the process for both the UP and DOWN Stomp Switch.
1
a.
Select a Wireless Stomp Switch to clear. Press and
hold the Pairing Button (
Stomp Switch for at least 5 seconds. It must be the
top right corner to initiate pairing. The three red LED's
under the button will begin to scroll in a clockwise
direction to indicate the switch is in Pairing Mode.
b.
The Wireless Stomp Switch will go into Pairing Mode
for 30 seconds. Once Pairing times out all Talon(s)/
Raptor(s) will be cleared.
c.
Repeat the complete clearing process for both
Wireless Stomp Switches.
Putting the Wireless Stomp Switch into
NOTICE:
Pairing Mode, even if it is accidental, without Pairing
the Wireless Stomp Switch to a Talon(s)/Raptor (s) will
clear all paired Talon(s)/Raptor(s).
©2024 Johnson Outdoors Marine Electronics, Inc.
or
) on the Wireless
1a
Auto Up Button
Pairing Button
Auto Down
Button
minnkota.johnsonoutdoors.com | 19
Publicité
