Publicité
Les langues disponibles
Les langues disponibles
PAIRING THE WIRELESS STOMP SWITCH
Two Talons and Programming the Mounting Location" section of the Talon Owner's Manual. If the two Talons are already Paired together,
a Wireless Stomp Switch can be Paired to either Talon. When the Pairing process is complete, the Wireless Stomp Switch will be able to
control both Talons.
PAIRING WITH A RAPTOR
Pairing a Wireless Stomp Switch to a Single Raptor
1
a.
Select a Wireless Stomp Switch to pair. Press and
hold the Pairing Button (
Stomp Switch for at least 5 seconds. It must be
the top right corner to initiate pairing. The three red
LED's
under the button will begin to scroll in a
clockwise direction to indicate the switch is in
Pairing Mode.
b.
Immediately press the Pair
Panel located on the Raptor Pump Assembly. The
PAIR/Maintenance LED will begin to flash
The Raptor and Wireless Stomp Switch will go into
Pairing Mode for 30 seconds. If a signal with three fast
beeps from the Pump Assembly occurs, the Raptor
and Wireless Stomp Switch have successfully paired.
If 30 seconds pass while in Pairing Mode and they do
not successfully pair, a chirp will sound from the Pump
Assembly, signaling that the Pairing has timed out.
c.
If the Pair is unsuccessful, repeat the process.
d.
Repeat the complete pairing process for both Wireless
Stomp Switches.
Pairing a Wireless Stomp Switch to Two Raptors
In order to Pair a Wireless Stomp Switch to the Raptor, please be
sure to first Pair the Raptors together. When two Raptors are Paired
together, any Wireless Stomp Switch that was Paired to an individual
Raptor will no longer be Paired. Please see the "Pairing Two Raptors
and Programming the Mounting Location" section of the Raptor Owner's
Manual. If the two Raptors are already Paired together, a Wireless Stomp Switch can be Paired to either Raptor. When the Pairing
process is complete, the Wireless Stomp Switch will be able to control both Raptors.
10 | minnkota.johnsonoutdoors.com
or
) on the Wireless
button on the Indicator
blue.
1a
UP
Mode
Button
LED
DOWN
Pair/Maintenance LED
Button
Auto Up Button
Pairing Button
Auto Down
For instructions on how to pair two Raptors and
NOTICE:
assign their Port and/or Starboard mounting locations,
please refer to your Raptor Owner's Manual.
PAIR/Maintenance
Button
Pump
Assembly
Indicator
Panel
Button
©2024 Johnson Outdoors Marine Electronics, Inc.
Publicité
