Using Your Robovac; Important Tips Before Use; Install The Charging Base - EUFY RoboVac R550C Manuel D'utilisation

English

Using Your RoboVac

Important Tips Before Use

a
d
a
Remove power cords and small objects from the floor that may entangle RoboVac.
b Fold tasseled edges of area rugs underneath to prevent tangling RoboVac. Avoid
cleaning very dark-colored high-pile rugs or rugs thicker than 0.87 in/22 mm as they
may cause RoboVac to malfunction.
c Keep RoboVac away from spaces lower than 3.9 in/100 mm to prevent RoboVac from
getting stuck. If necessary, place a physical barrier to block off the problem areas.
d Keep RoboVac away from wet areas.
e RoboVac may climb on top of objects less than 0.59 in/15mm in height. Remove these
objects if possible.
f Anti-drop sensors prevent RoboVac from tumbling down stairs and steep drops.
They may work less effectively if dirty or used on reflective/very dark-colored floors.
Although the Boundary Strip(s) can be applied to block off the areas you do not
want RoboVac to clean, they should not be solely relied upon to avoid a potentially
dangerous situation. In such cases, it is recommended to place physical barriers to
block off problem areas where RoboVac may fall.
Place physical barriers in front of fireplaces and areas that may cause damage to
RoboVac if entered.
08
c
b
e
f

Install the Charging Base

Place the Charging Base on a hard, level surface and against a wall.
Remove objects within 3 ft/1 m of the left and right side and within 6 ft/2 m of the
front of the Charging Base.
Connect the round connector of the adapter into the power socket on the Charging
Base and the other end into a wall outlet.
- The LED indicator on the Charging Base is SOLID GREEN when RoboVac is NOT docked.
- The LED indicator on the Charging Base is OFF when RoboVac is docked.
English
- Install the Charging Base in a
location that RoboVac can easily
access.
- Always keep the Charging Base
plugged in, otherwise RoboVac
will not automatically return to it.
09