Led Indication; Using Your Robovac; Important Tips Before Use - EUFY RoboVac R500 Manuel D'utilisation

English

LED Indication

You can see the status of RoboVac from the LED indicator.
(Status Light) Status
Breathing orange Charging
Solid blue Standby / Cleaning / Fully charged
Solid orange Low power and returning to Charging Base
• RoboVac is off.
• To conserve power, the light automatically turns off
Off
when RoboVac is not docked to the Charging Base
and has been inactive for 1 minute.
RoboVac has an error.
Flashing / Solid red + Beeping
Refer to the "Troubleshooting>Error Tone" section in this
manual for solutions.
08

Using Your RoboVac

Important Tips Before Use

a
b
d e
a
Remove power cords and small objects from the floor that may entangle RoboVac. You
can use the supplied cable ties to organize your wires and power cords.
b Fold tasseled edges of area rugs underneath to prevent tangling RoboVac. Avoid
cleaning very dark-colored high-pile rugs or rugs thicker than 1.02 in/26 mm as they
may cause RoboVac to malfunction.
c Keep RoboVac away from spaces lower than 2.87 in/73 mm to prevent RoboVac from
getting stuck. If necessary, place a physical barrier to block off the problem areas.
d Keep RoboVac away from wet areas.
e RoboVac may climb on top of objects less than 0.63 in/16 mm in height. Remove these
objects if possible.
f Anti-drop sensors prevent RoboVac from tumbling down stairs and steep drops. They
may work less effectively if dirty or used on reflective/very dark-colored floors. It is
recommended to apply the Boundary Strip(s) to block off areas where RoboVac may
fall.
Place physical barriers or Boundary Strips in front of fireplaces and areas that
may cause damage to RoboVac if entered.
English
c
f
09