Use The Boundary Strip; Cleaning And Maintenance; Clean The Dust Collector And Filters - EUFY RoboVac R550C Manuel D'utilisation

English

Use the Boundary Strip

With the Boundary Strip, you can keep RoboVac away from any area or item you do not
want RoboVac to clean. RoboVac will recognize the Boundary Strip and will not cross into
the blocked-off area.
Identify the area or item you do not want RoboVac to clean.
If necessary, use scissors to cut the Boundary Strip to a shorter length. Be sure to
correctly measure the length before cutting. The minimum length you should cut to is
19 in/483 mm.
Apply adhesive tape to lay the Boundary Strip flat on the floor. Make sure the strip is
placed FLAT on the floor.
- If the Boundary Strip is rolled up, remove and then re-apply on the floor with adhesive
tape. Otherwise the Boundary Strip may not work well.
- Be careful not to damage the floor when using adhesive tape. It is not recommended
for use on carpets.
- Keep the Boundary Strip away from objects that emit excessive heat.
18

Cleaning and Maintenance

Clean the Dust Collector and Filters

Press the dust collector release button to pull the dust collector out.
Open and empty the dust collector.
1 2
Separate the pre-filter by pulling the hooks as shown.
Take out the foam filter and high-performance filter.
3 4
Clean the dust collector and filters with a vacuum cleaner or a cleaning brush.
Put the filters back together in the dust collector.
English
19