Mitsubishi Electric ECOV-X37VA Manuel D'installation page 16

3-3. Transporting and unpacking the unit
1) Transporting the unit
• Do not lift the unit. The unit must not be lifted and carried by hand.
The handles on the unit are intended to be used for positioning during installation.
• If PP bands are used on the package of the unit, do not lift the unit in a way that applies a load on any of the PP bands.
• The unit must be upright during transportation and installation.
2) Unpacking the unit
• Plastic bags can pose suffocation and choking hazards. Keep out of the reach of children and tear them before disposal.
3) Lifting the unit
• If the unit needs to be lifted for installation, pass ropes through the two hanging parts at right and left under the unit.
• The ropes must support the unit at four points. Take measures to prevent any shock to the unit while it is lifted.
• The roping angle must be within 40 to 60 degrees as shown in the figure below.
• Use two ropes with sufficient length. <7 m or longer>
The thickness of the ropes must match the size of the rope suspension parts.
If the ropes are too thin, they may break and cause the unit to fall.
• The surfaces of the unit that come into contact with the ropes may be scratched if unprotected. Use rags or cloths to protect
the surfaces.
Protection pad
X
Protection pad
Model
Weight (kg)
X (mm)
Y (mm)
Z (mm)
WT09614X03_GB
Protection pad
Center of gravity
Protection pad
Z
ECOV-X37VA,
ECOV-X55VA
290
857
608
215
16
40 to 60
degrees
Center of gravity