Mitsubishi Electric ECOV-X37VA Manuel D'installation page 23

Sandwich the damper pad between the unit and the base.
ø18 hole
75 mm
Vibration damper pad (example)
6-1-4. Sound insulation work
Attach sound insulation boards around the unit when installing the unit on a base that is more than 300 mm tall. (See the
figure on the right.)
However, keep a space of approximately 100 mm over
the boards because complete insulation may interrupt the
ventilation in the unit (or the machine room or the control
box may not be cooled).
6-1-5. Removing protection materials for transportation
Remove the packing materials from the unit and properly dispose of them after the installation.
Unit operation without removing the packing materials may cause injury or damage the unit.
Procedures for removing the plates for transportation
1. Unscrew two screws to remove transportation plate 1.
2. Unscrew two screws to remove transportation plate 2.
Approx. 8 mm
Two screws
Sample of concrete base
Sound insulating board
Approx. 100 mm
Airflow space for
ventilation
Transportation plate 1
Two screws
Transportation plate 2
23
Vibration
damper pad
WT09614X03_GB