Publicité
Les langues disponibles
Les langues disponibles
Page | 16
Coté droit (assis sur la moto)
Prendre le boulon M10x100 restant (ARTICLE 10) et insérer la rondelle M10 restante
(ARTICLE 5) autour du filetage du boulon.
Prendre la rondelle de blocage restante (ARTICLE 11) et placez là contre la rondelle qui vient
d'être insérée.
Placer cet ensemble à travers la protection (ARTICLE 2) de façon à ce que la tête du boulon et
les rondelles aillent dans le contre alésage de la protection crash.
Placer l'entretoise restante (ARTICLE 3) autour de l'extrémité du boulon pour qu'elle se place
contre la protection crash.
Monter l'ensemble dans le filetage du support de fixation (Photo 'D').
Placer le Nyloc M10 sur l'extrémité du boulon (Photo 'F').
Serrer le boulon avec une clé de 17mm jusqu'à ce que vous sentiez une légère compression
de l'intérieur de la protection. LA PROTECTION DOIT ETRE POSITIONNEE COMME EN "C"
AVEC LE COTE ARRONDI LE PLUS GROS EN DIRECTION DE L'AVANT DE LA MOTO. Tourner
un peu plus afin d'accentuer légèrement la compression. Ne pas trop serrer, au risqué
d'abîmer la moto. Pas plus de 40 Nm de couple.
S'assurer que la protection crash ne viendra pas en contact avec le carénage lorsque le boulon
est serré).
Mettre les capuchons aux protections (ARTICLE 1)
Coller les stickers R&G.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other
than those in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality
and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable
skill and care and rectify any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return of any defective Products
R&G shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have
been modified or used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good
engineering practice or if the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting
its liability for causing death and personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability
shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect
the Buyer's statutory rights.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
PHOTO D
Issue 1 12/04/2013 (NSY)
CONSUMER NOTICE
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
PHOTO F
R&G Racing
www.rg-racing.com
Email:
info@rg-racing.com
Publicité
