Publicité
Les langues disponibles
Les langues disponibles
Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
13. EQUIPMENT IDENTIFICATION
•
Located on the plate affixed to the machine to detect the technical data.
•
Check the model and power supply voltage before carrying out any operation.
•
If discrepancies are found, immediately contact the manufacturer or the company that supplied the equipment.
1.
Manufacturer
2.
Code
3.
Conformity marking
4.
Power supply voltage (V)
5.
Power supply frequency (Hz)
6.
Absorbed electrical power (W)
7.
Absorbed electrical power in defrosting (W)
8.
Light max. power (W)
9.
Gross volume
10. Type and quantity of refrigerant
11. Climate class
It is strictly forbidden to remove, tamper with the plate and change or alter the
data contained in it.
14. ENERGY SAVING TIPS
•
Install the appliance in a dry, well-ventilated room away from heat sources (radiator, cooking surface and so on) and in a position
out of direct sunlight.
•
Follow the installation instructions to ensure adequate ventilation. Insufficient ventilation to the back of the appliance causes an
increase in energy consumption and reduces cooling efficiency.
•
The internal temperature of the appliance depends on the room temperature, how often the doors are opened and where the
appliance is placed. These factors have to be taken into account when setting the thermostat. Only open the doors when strictly
necessary.
•
Let hot food and drink cool down before placing them in the appliance.
•
The positioning of the shelves in the fridge has no effect on energy efficiency.
•
The fridge compartment light system uses a LED light, which at the same time ensures more efficient lighting and reduced energy
consumption.
15. PUTTING INTO OPERATION
If the cabinet has been sharply tilted while being sited or for mounting of accessories, it must be left to stand for
at least three hours before being started to allow the lubricating oil to settle in the compressor.
Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR WILL
HAVE TO BE CONNECTED IS TO BE PROTECTED BY A VERY
SENSITIVE DIFFERENTIAL SWITCH (Rc=16A,Dc=30mA); IT
IS ALSO TO BE LINKED TO THE GENERAL EARTHING PLANT.
Earthing is necessary and compulsory by law.
Absolutely never use reduction units, patch cords, adapters or multiple
socket outlets to connect the counter. DIRECTLY connect the equipment
to the mains.
The cable should be fully extended and located where it is unilikely to be struck, caught or stepped
on, away from water and the other liquids and heat sources and must not be damaged. In case of breakage of the
power cable of the cabinet, it must be replaced by the manufacturer or by instruction it change of it.
Follow the manufacturer's instructions to install the unit, using qualified personnel and complying with the electrical
regulations for the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or things due to
incorrect observance of this rule.
DELIGHT 16
DELIGHT 18
DELIGHT 20
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
1
6
4
5
7
9
8
3
2 5 / 8 4
PAGE
UM000494
N° DOC
2
10
11
*Example of data plates
11
Publicité
