Télécharger Imprimer la page

Olimpia splendid ARYAL S1 E TRIAL INVERTER 21 Mode D'emploi Et D'entretien page 78

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 99
A
min.
300
mm
C
• Another option (figure 16) is to position the gasket (6) on the fitting (5) and then insert the latter into the
hole made on the bottom of the outdoor unit and turn it by 90° to fix it securely.
• Connect a rubber hose (not supplied) to the fitting (6) if water is drained from the outdoor unit in heating
mode.
2.6.2 - Outdoor unit assembly
Proceed as follows (as described in the previous paragraph), once the ideal position for installation of the
outdoor unit has been identified:
a. Position the unit on the support base, respecting the drilling distances indicated in the table in figure X4.
b. Screw any clamping nuts, without tightening completely.
c. Using a spirit level, check the unit is level; if necessary, adjust the support feet.
d. Tighten any clamping nuts correctly.
IN = air inlet - OUT = air outlet
IN
F
1
e. If the outdoor unit is higher than the indoor units, to prevent rain entering, a downward bow must be made
along the connection pipe (siphon) before the connection pipe enters the wall. This is to guarantee that
the lowest point of the connection pipe is outdoors.
2.6.3 - Execution, installation and connection of the refrigeration lines
Do not make the connections using normal hydraulic piping, which could contain
scrap residues, dirt or water, and which can damage the unit components and
jeopardise correct operation of the appliance.
EN - 22
min.
300
mm
min.
600
B
min.
700
mm
IN
OUT
F
2
mm
DUAL
INVERTER
Model
14
1x2
"F1"
340
"F2"
614
D
min. 600
mm
E
min.
300
mm
C
A
DUAL
TRIAL
INVERTER
INVERTER
18
21
1x2
1x3
340
350
614
540
F
X
4

Publicité

loading

Ce manuel est également adapté pour:

Aryal s1 e dual inverter 18Aryal s1 e dual inverter 14