Olimpia splendid ARYAL S1 E TRIAL INVERTER 21 Mode D'emploi Et D'entretien page 75

2.5 - INSTALLATION OF THE INSIDE UNIT
2.5.1 - Installation of fastening plate
After having checked that described in paragraph "2.2"and on the previous page (figure X1), assemble the
fixing plate (7) taking the dimensions stated in figure X2 into consideration.
a. Position the plate against the wall.
b. Mark the drilling points, making sure that they are level.
c. Make the holes necessary in the wall using a suitable bit.
Make sure there are no pipes or electric ducts in the drilling area.
d. Insert the plugs (4) into the holes and fix the plate (7) to the wall using the screws (3) supplied (figure 5).
Using a spirit level, make sure that the fixing plate (7) is level.
e. If the wall is in wood, use relevant countersunk-head screws (not supplied).
f. Check the stability of the plate (7), moving it laterally and vertically.
2.5.2 - Realisation of pipe passage holes
If the connection lines arrive from the rear right of the indoor unit, a hole "R" must be made for passage of
the piping, as successively described (see figure X2).
a. Make a 8÷10 mm hole in the centre of the position "R", with slope towards the outdoors of 5% (to allow
condensate to be drained correctly (figure 6).
b. Make the hole "R" using a core drill with the diameter indicated in the table of figure X2.
c. Insert the drain line piping and that of refrigeration into the hole along with the electric connection cable.
If the connection lines arrive from the rear left of the indoor unit, a hole "L" must be made for passage of the
piping (see figure X2).
X fixing bracket
2
indoor unit
L
B
ø
H
Model
B (9 - 12)
C (18)
ø
H
R
ø
H
L R
mm mm
230 246
285 243
L
C
H
mm
65
65
R
ø
H
ø
mm
65
65
EN - 19
ARYAL S1 E