Publicité
Les langues disponibles
Les langues disponibles
T_SEN1: Thermal Sensor Connector
This connector allows you to connect the thermistor cable and use it to monitor the
temperature of the detection point.
V-Check Points Lite
These voltage checkpoints are used to measure the current system voltages. A
multimeter (not included) will be required to check voltages. To measure voltage,
place test leads on the GND (screw mounting hole) and a specific V-Check Point.
Please refer to the manual of your multimeter for more information.
32
Overview of Components
Sense
GND
GND
VCCIO2
VCCIO
VSA
DRAM
VCORE
Thermistor cable
Publicité
