Sigma BC 16.12 Mode D'emploi page 15

2. Functions / Properties
The total values are only separately displayed for
bike 1, bike 2 and bike 1+2 once a second bike has
been added. If only one bike is used, only the total
values for the first bike are displayed.
– Light manager Simultaneously press the SET and

RESET buttons to switch the light function on/off.
The display lights up by pressing any button; the bike
computer changes to the respective function when the
button is pressed again. On STS devices, the light
function is disabled during synchronization (max.
5 minutes). Avoid using the backlight unnecessarily
to save the battery!
– Service interval
The service interval informs

you when you have cycled a specified number of
kilometers and a bike inspection is due. This
service interval can only be enabled/disabled
and pre-configured by your specialist retailer.
The device comes with the service interval disabled.
– Battery status
The battery status of the

computer head unit is displayed shortly before
the battery runs out.
on the display. After changing the battery, only the
time needs to be re-set.
– Memory chip Thanks to an inbuilt memory chip,

all total values and settings are permanently stored
in the bike computer. This means that you do not
need to reconfigure any settings (except for the
time) after changing the battery.
– PC compatibility
The bike computer is

PC-compatible. After purchasing the SIGMA
DATA CENTER software and docking station,
you can simply and effortlessly log your total
and current values on your PC. You can also
configure your bike computer's settings on the PC.
www.sigma-data-center.com
"low/computer" appears
15