Nolan N120-1 Sécurité Et Instructions D'utilisation page 24

N120-1
4 ASSEMBLING THE LINER
4.1 Insert the liner correctly into the helmet and have it well fitted against the base.
4.2 Insert the central front tab of the liner into its seat on the support fixed to the pol-
ystyrene inner shell and push it downwards until it is completely locked (Fig.22).
Then repeat the operation with the left and right flaps making sure that the side
ends of the liner are placed between the external side frames and the polystyrene
inner shell.
Warning: check the correct assembly of the liner front area by lifting and lowering
the VPS, that should be able to move freely. If this is not the case, repeat the steps
3.2 and 4.2.
4.3 Insert the liner rear right and left tabs into their corresponding housings of the shell
edge (Fig.21). Push the tabs until they are fully fastened onto the support.
5 ASSEMBLY OF INNER EXPANDING FOAM PADDING OF THE CHEEK PADS
5.1 Gently insert the inner expanding foam padding inside the left cheek pad fabric lin-
ing (Fig.19). Carefully stretch the padding while checking that there are no creases
in the cheek pad fabric lining.
5.2 Unhook the two eyelets "A" of the rear frame of the left cheek pad slot next to the
two snap buttons (front and rear) on the back (Fig.18).
5.3 Follow these operations with the right cheek pad padding.
6 ASSEMBLING CHEEK PADS
WARNING
Take the padding of the left cheek pad and ensure that rear "B", front "A" and top "A"
snap buttons are correctly hooked to the rear frame of the fabric lining of the cheek
pads (Fig.20). Otherwise, position them again appropriately.
6.1 Insert the rear tab of the comfort padding of the left cheek pad into the cavity
between the rear trim and the polystyrene inner shell (Fig.17).
6.2 Insert the chin strap into the cavity in the cheek padding and press near the rear
snap fasteners located on the back to fasten it to the relevant seat in the polysty-
rene cheek pad (Fig.16).
6.3 Check whether the fasteners are correctly fastened by slightly pulling the cheek
pad towards the inside of the helmet and checking that it keeps adhering to the
polystyrene cheek pad.
6.4 Follow these operations with the right cheek pad padding.
Warning: the buttons are not fastened until a click is heard. Check that the strap
comes out properly from the cheek pad padding.
6.5 Insert the chin strap band into the elastic loop on the cheek pad strap (Fig. 15).
WARNING
If your helmet is equipped with the D-Ring retention system, close it as de-
-
scribed in the attached D-Ring instruction label available under www.no-
lan-helmets.com
- Remove the inner comfort padding only when cleaning or washing is required.
- Never use the helmet if the inner comfort padding and the cheek pads have not
been correctly and completely fitted.
22
INSTRUCTIONS FOR USE