Nolan N120-1 Sécurité Et Instructions D'utilisation page 19

VISOR ( NMS-05S or NMS-05L, depending on helmet size )
1 DISASSEMBLY
1.1 Close the chin guard (if open) and set the visor in completely open position.
1.2 Push the release lever of the left side mechanism completely backwards (Fig.6)
and simultaneously push the visor forward initially projecting the top hook "A"
(Fig.7A) and then the lower hook "B" from the corresponding seats in the side
mechanism (Fig.7B).
1.3 Follow the previous operations on the right side of the helmet.
2 ASSEMBLY
2.1 Close the chin guard (if open) and check that the side mechanisms are in full open-
ing position (Fig. 8).
2.2 Place the visor left side on the corresponding side mechanism by inserting the
visor inner pin into the mechanism central housing (Fig.7B).
2.3 Rotate the visor towards the side mechanism by inserting the top hook "A" into the
corresponding seat in the side mechanism itself so that the release lever retracts
and then returns to its position, hooking the visor to the side mechanism with a
click (Fig.7A).
2.4 Follow the previous operations on the right side of the helmet.
2.5 Close the visor completely.
WARNING
- Check that the mechanisms are working properly. Open and then close the visor:
by raising the chin guard, the visor will remain in its maximum open position. If
necessary, follow the previous operations mentioned above.
- Check that the mechanisms are working properly: open and close the visor, mak-
ing sure that it is retained firmly to the side mechanisms; open the chin guard and
check that the visor opens and remains in full opening position; close the visor and
check that the chin guard closes back to the maximum open position. If neces-
sary, follow the previous operations mentioned above.
- Do not use the helmet if the visor has not been properly assembled.
- Do not remove the side mechanisms from the chin guard.
- Should any of the side mechanisms fail or be damaged, please contact a Nolan-
group authorised dealer.
MINIMUM OPENING POSITION WITH DEFOGGING FUNCTION
Visor mechanisms allow the visor to have stable intermediate positions. Starting from
the full closing position of the visor, it is possible to open it slightly by placing it in a
stable minimum opening position to improve ventilation and facilitate defogging, espe-
cially at low speeds or during short stops.
( NMS-05S o NMS-05L, depending on helmet size )
(Available as standard or accessory/spare part)
1 ASSEMBLY
1.1 Disassemble the visor (see instructions above).
INSTRUCTIONS FOR USE
N120-1
17