Nolan N120-1 Sécurité Et Instructions D'utilisation page 22

N120-1
- At night and/or in conditions of poor visibility, the VPS should be deactivated.
- Should sunglasses and/or photochromic lenses be used, the VPS should be de-
activated.
- Always check that the VPS is properly placed according to the different weather/
environmental conditions and/or to the above mentioned recommendations for use.
- Use the special slider to activate/deactivate the VPS; do not deactivate the VPS
by handling it directly.
- Always check that the VPS is clean and that it is properly working in order to avoid
scratches and/or anomalous wear on it every time it is activated.
- As for VPS and visor maintenance and cleaning operations, please refer to the
appropriate section in the helmet user's manual.
- The VPS scratch-resistant/fog-resistant treatment highly reduces fogging. Howev-
er, protracted periods of adverse weather and/or environmental conditions might
cause fogging and/or formation of condensation on the VPS, which entails a re-
duction of visibility and/or sharpness of vision: in this case, deactivate the VPS.
- In case of rain, the direct contact of raindrops with the scratch resistant/fog-resist-
ant treated VPS quickly reduces sharpness of vision, thus causing scarce visibility:
in this case, deactivate the VPS.
- The special VPS fog-resistant treatment is usually sensitive to high temperatures
or heat sources. In this case, contaminations caused by contact with other ma-
terials might occur. These contaminations will cause marks and stains to come
out. In these cases (e.g., when the helmet is kept in the top case on hot days), it is
recommended that the VPS does not come into contact with other materials.
3 DISASSEMBLY
3.1 Open the helmet chin guard and lower the VPS completely (see instructions
above) (Fig.12).
3.2 Hold the left lateral part of the sunscreen and pull it toward the outside of the
helmet (Fig. 14).
3.3 Follow the same operation on the right side of the helmet.
4 ASSEMBLY
4.1 Open the helmet chin guard and move the side slider until it stops (see instructions
above) (Fig.12).
4.2 Insert the sunscreen left end into the guide until it is completely fastened to the
shell housing (Fig.14).
4.3 Follow the same operation on the right side of the helmet.
WARNING
Check that the VPS is properly working by activating and deactivating it (see
-
instructions above). If necessary, follow the previous operations mentioned
above.
- If the VPS opening and closing mechanisms are not working properly or if such
mechanisms get damaged, please contact a Nolangroup authorized dealer.
- Do not use the helmet if the VPS has not been assembled properly.
- Since the VPS does not assure you the same protection as the one provided by
the visor, it has to be used only when the helmet visor is lowered.
20
INSTRUCTIONS FOR USE