Nolan N120-1 Sécurité Et Instructions D'utilisation page 18

N120-1
DUAL ACTION
This unique chin guard opening system - positioned in the centre of the chin guard - al-
lows for easy, one-handed opening and prevents it from accidentally opening. The chin
guard can only be opened after operating the first red lever (release lever) and then the
second red lever (opening lever).
The configuration with chin guard open and VPS raised is recommended to
ensure a better fit of the helmet.
1 CHIN GUARD OPENING
1.1 Push the red release lever outwards by turning it with your thumb (Fig.1).
1.2 Place your forefinger on top of the opening lever and push it downwards to unlock
the chin guard (Fig.2).
1.3 Pull the chin guard forward and accompany it in its rotational movement upwards
(Fig.3) until it reaches its stop position on the back of the shell (Fig. 4).
1.4 Regardless of the initial position of the visor, this one will remain in its maximum
open position after the chin guard has been opened.
If the helmet is used with chin guard open (J configuration), it is recommended
that you place the left side locking slider in position "J" to secure the chin guard
in this position (Fig.5B).
2 CHIN GUARD CLOSING
WARNING
When the left side locking slider is in position "J" do not force the closing of the
chin guard because it could damage the helmet's closing mechanism. Move the
locking slider to position "P" (Fig.5A) to close the chin guard.
2.1 Pull the chin guard forward, accompanying it as it rotates, until you hear the clicks
of the closing mechanism (Fig.3).
2.2 Regardless of the initial position of the visor, the visor will remain in its maximum
open position after the chin guard has been closed.
2.3 Make sure the chin guard is correctly fastened by pulling it forwards and by check-
ing that both sides remain fastened to the shell.
When the left side locking slider is in position "P", the chin guard can be
opened and/or closed (Fig.5A).
When the left side locking slider is in position "J", the chin guard cannot be
closed and remains blocked in open position (Fig.5B).
WARNING
- The protection level of this helmet whilst riding depends on the configuration
adopted by the user: total protection if the chin guard and visor are closed,
partial protection if the chin guard and/or visor are open.
- Do not remove nor tamper with the fixing screws that connect the chin guard to
the shell.
- Do not use the helmet without chin guard.
- Never use the helmet in case of malfunctioning and/or damages of the chin guard
opening system. In case of doubts regarding the correct operation of the chin
guard opening mechanism, contact a Nolangroup authorized dealer.
16
INSTRUCTIONS FOR USE