REX BX-400 E Mode D'emploi page 34

Assembly
STEP 3
STEP 4
GB-34
REX_Trainer_BX400E_12.indd GB-34 REX_Trainer_BX400E_12.indd GB-34
WARNING
1. Connect the upper computer cable to the lower com-
puter cable (64 + 65) (see Fig. b).
2. Push the handlebar support tube (29) with cover
(28) onto the main frame (1) (see Fig. a).
Make sure not to pinch the computer cable.
3. Now fasten the handlebar support tube with six Allen
screws (20) and six washers each (13 + 72) to the
frame.
4. Clamp the handlebar (36) in the handlebar locking
clamp.
5. Fix the handlebar with the cover (42) using the
locking screw (37), the washer and the spring washer
(43 + 44) as well as the spacer sleeve (45).
6. Pull the pulse sensor cable (30) of the handlebar up
through the side holes in the handlebar support tube
(see Fig.).
WARNING
1. Assemble the left (46L) and the right (46R) pedal.
During the assembly, make sure that both pedals are
installed on the respectively correct side, otherwise
they could break out. The right pedal is screwed in
clockwise and the left pedal is screwed in anti-clock-
wise. For better identifi cation, the pedals have been
marked with an "L" for left and an "R" for right.
Tighten both pedals fi rmly.
2. Connect the upper computer cable (64) and the cable
of the pulse sensors (30) to the display (38).
3. Fix the display with four screws (59) to the handle-
bar support tube.
Assembly
20.06.12 10:31 20.06.12 10:31