BH FITNESS G6508D Mode D'emploi page 22

FAULT FINDING CHART
PROBLEM
1. The monitor does
not switch on.
2. The monitor
switches on but
the motor fails to
start.
3. Walking motion is
jerky on the
treadmill
4. The machine
stops (the breaker
trips)
5. Electrical shocks
through the
handrail.
6. The treadmill belt
skews off centre
ERROR CODES
Monitor screen displays E1
Monitor screen displays E6-E7
Do not hesitate to get touch with the Technical Assistance Service if you have any
queries by phoning customer services (see last page in manual)
CHECKS
1)Make sure that the machine is plugged
in, the ON/OFF switch in position I
and that the safety key is inserted.
2) Check that the current limiter is
pressed in.
3.a) Check that the belt is lubricated.
3.b) Check the tension on the sliding
belt.
3.c) Check the tension on the drive belt.
4) Check that the band is lubricated
5) Check that the machine is plugged
into an earthed mains socket.
6.a) Check that the machine is level on
the floor
6.b) Check that the machine does not
wobble.
- Speed sensor fault.
- Elevation fault
22
SOLUTIONS
1) Plug the machine into the
mains supply.
Set the switch to position I
and insert the safety key.
2)Switch the machine off and
press the circuit breaker
in. Lubricate the treadmill
band.
3.a) Lubricate the sliding belt.
3.b) Adjust the belt tension.
3.c) Adjust the drive belt
tension.
4)Reset the overload button
with the On/Off switch at
"0" and lubricate the
treadmill band.
5) Plug the machine into an
earthed mains socket.
6) Use the adjustable feet to
level the machine.