HOLZMANN MASCHINEN BS712TOP Mode D'emploi page 37

16.5 Adjusting the cutting angle
16.6 Adjusting the saw blade speed
HOLZMANN MASCHINEN GmbH

BS712TOP
BS712TOP-G
www.holzmann-maschinen.at
Use the adjustable workpiece fence to cut
workpieces of the same length.
The cutting angle between vice and saw
blade can be adjusted within the specified
angle range.
Procedure:
 Loosen nut (1)
 Move the vice jaw to the desired
position (scale 2) and retighten the
nut.
 - Tighten the clamping screw after
clamping the workpiece with the vice
jaws (3)
1. stop machine and wait for standstill
2. open the V-belt cover
3. loosen the V-belt tension:
To do this, loosen the motor fixing screws
4 pieces (1). Loosen the belt tension with
tensioning screws (2) and select the
desired saw blade speed by turning the
belts according to the diagram and re-
establisch the V-belt tension.
4. close the V-belt cover again
OPERATION
37
BS 712TOP; BS712TOP-G