HOLZMANN MASCHINEN BS712TOP Mode D'emploi page 35

16 OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
16.1 Operation instructions
Carry out all setting and adjustment work only after disconnecting from the
electrical mains!
Check the machine before starting work:
Safety devices in place and in good condition

Check saw blade for wear and tear and replace if necessary

Check coolant level and fill up if necessary

Check moving parts for ease of movement

Check all components for correct seating and functioning especially the

screws of saw blade guard and the lever.
All tool for maintenance/servicing removed from machine.

Place the saw blade guard as close as possible to the workpiece

Check before each cut:
Cutting angle correctly adjusted?

Vice fixed?

Make sure that the material to be machined is properly fixed in the vice.

Mare sure that coolant circulates properly.

Saw band direction correct?

 Long workpieces must be support (eg stand, roll stand,...)
 Always run teh motor at full speed before you start cutting (wait at least
30sec after starting the saw blade)
 Never start the machine with the saw blade pressed down (10mm distance)
16.2 Operation
16.2.1 Switching the maschine ON/OFF
16.2.1 Switching the coolant pump ON/OFF
HOLZMANN MASCHINEN GmbH
WARNING
NOTICE
www.holzmann-maschinen.at
The saw blade is started by pressing the
button (1).
Saw blade is stopped by pressing the button
(2).
Coolant pump is started by pressing the
button (3).
Coolant pump is stopped by pressing the
button (4).
OPERATION
35
BS 712TOP; BS712TOP-G