Cooke & Lewis CLCHS70 Manuel D'instructions page 6

Trouble shooting
Problem
Excessive vibration.
The light is on, but the
fan does not work.
Both the light and
motor do not work.
Suction
performance reduced.
Works normally but
cooking smells linger.
This appliance respects laws of the suppression of radio interference. As the Manufacturer has
a policy of continuous product improvement, it reserves the right to adapt and carry out any
modification considered necessary without prior warning.
Kingfisher International Products Limited, 3 Sheldon Square, London, W2 6PX, United Kingdom
Commercial guarantee
At Cooke and Lewis we take special care to select high quality materials and use manufacturing
techniques that allow us to create ranges of products incorporating design and durability. That's why
we offer a 24 months' guarantee against manufacturing defects on our chimney hood.
This chimney hood is guaranteed for 24 months from the date of purchase, if bought in store, or
delivery, if bought online, for normal (non-professional or commercial) household use. You may only
make a claim under this guarantee upon presentation of your sales receipt or purchase invoice.
Please keep your proof of purchase in a safe place.
The guarantee covers all parts and labour costs associated with the repair of the chimney hood if it
is found to be defective due to faulty materials or workmanship within 24 months from the date of
purchase or delivery subject to the exclusions set out below and provided it was used for the purpose
for which it is intended and subject to installation, cleaning, care and maintenance in accordance
with the information contained in the user manual. This guarantee does not cover defects and
damage caused by normal wear and tear of chimney hood and damage that could be the result of
improper use, faulty installation, storage or assembly, neglect, accident, modification of the product,
consumable items such as carbon filters and bulbs.
6
Possible cause
The appliance is not installed
properly on the brackets.
The fan blade is damaged.
The fan motor is not fixed tightly.
The fan blade is jammed.
The motor is damaged.
Light bulb blown.
Power connection loose.
Speed may be too low.
Aluminium filters
are dirty.
Top vent might be
obstructed.
Optional vent kit might be twisted.
The installation may not comply with
the manufacturers instructions.
Carbon filter is not fitted in
recirculation mode or is full
of grease.
Solution
Take down the appliance and check
it is properly fixed.
Switch off the appliance. Repair to
be carried out by qualified service
personnel only.
Replace with a bulb of the
correct rating.
Check power supply.
Select a higher speed.
Clean the aluminium filters. (See
Care and maintenance section).
Clear any obstruction.
Ensure that the vent kit
is fitted according to the
manufacturer's instructions.
The vent hose should be correct
diameter throughout with no
reductions or restriction.(See
installation section).
Fit carbon filter or replace the
carbon filter (See Care and
maintenance section).